PDA

View Full Version : Oct 29th ...


Melody
Oct 24th 2006, 05:18 PM
I received the following useful information from Kanetix (http://www.qksrv.net/click-956580-58606) (Canadian Insurance comparison site):


Daylight Saving Time Ends
Sunday, October 29 at 2 a.m.
Don't forget to turn your clocks back one hour

The weekend most Canadians fall back one hour is also the ideal time to tackle seasonal safety projects we often put off. A lot of the routine maintenance on your home and car should be done twice a year, so what better time to start checking items off your "To do" list?

Around the house

Replace the batteries in your smoke detectors and test to make sure the detectors still work.
Replace the batteries in your carbon monoxide detectors and test to make sure the detectors still work.
Even if the batteries are not dead, changing them will ensure they are working when you need them.
Now that you've turned on the furnace, make sure it's working properly and efficiently. Make an appointment to have your furnace cleaned and inspected by a qualified technician.
Clean gutters and downspouts to keep debris from accumulating. This is especially important now that the leaves are falling.
Have your chimney cleaned so your fireplace will be ready for use.
Bring out of hiding, all the winter gear you'll need to clear your walk, like shovels and sand.In your car

Remove your golf clubs from the trunk and replace with a winter weather car safety kit. You can buy one or make your own. Usually kits include items like a shovel, ice scraper and brush, booster cables, a blanket, extra set of gloves, flares, matches, candles and anything else you might think of that can help if you have car problems.
Change your wipers blades. They should be replaced every six months because wipers that do not work are dangerous - you can't drive if you can't see!
If you change your tires seasonally, now is a good time to put your winter tires on. Store your summer wheels in a cool, dry location, laid down flat and stacked on top of each other no taller than 4 feet high. This offers the most support and should eliminate any fitting problems the following spring.
If you don't change your tires seasonally, check your tire pressure and treads. After all those summer road trips, you want to make sure your tires are ready for the winter roads. If your tire pressure is off you'll notice irregular and uneven wear on your treads, reduced vehicle handling or decreased gas mileage.

Soggybottom
Oct 27th 2006, 09:49 PM
I found this info at school this week. I know my folk's lawnmower would be working a lot better if they knew how to take care of it properly. Maybe someone else could use the info on how to do a complete winter service. With the exception of maybe a spark plug gap checker (cheap), most people have all the tools they need. You'll need the manual for some specs. The author assumes no responsibility for destruction or accidents and does assume the reader knows basic safety practice around powered equipment.

Around the garage (winterizing power tools and power toys)
If your engine is running like crap to begin with, ask at Lordco or Can Tire for "tuneup in a can" It is quite effective at dislodging carbon and sludge buildups before you do the rest of this stuff. Spray into air intake like a fogging spray (see 2nd to last step)
OIL - After running engine until warm (stirs up sludge), stop it and completely drain engine oil and replace with new. Larger machines may have an oil filter that should be replaced.
AIR FILTER - Open the housing and clean inside the entire area. Check paper filters against the light, if you can't see through them, replace them. Sponge type filters should be replaced or washed out with soapy water, dried and then lightly dampened with oil (no drips)
SPARK PLUG - Unscrew and inspect for damage or wear. Replace if neccessary (adjust gap, they are not pre-set in the box)
Put fuel stabilizer in gas tank
With air filter off, oil changed and gas stabilized, run engine until warm, and bring back to an idle. Spray "fogging spray" (ask at store) into air intake until there is smoke pouring out of the exhaust and keep spraying until the engine dies. This seals the inside of the engine against rust and corrosion.
Put everything back together, wash everything off. Larger machines may have grease nipples, grease them with a grease gun (like a caulking gun with a short hose and an attachment for the nipples) Do this after washing to push any water out of the joints.Batteries are also easy to do but there are a few types and you'll need another little gadget, just ask if you want to try it. At the least, charge them to max and store in the coldest, most consistent temperature you can find until spring (ideally the deep freeze)

Anyway, hope someone finds that useful. We had lots of girls in class, so anyone can do it :laugh: but if you are not mechanically inclined there are a few precautions and things to keep in mind, just ask...

Melody
Oct 28th 2006, 04:54 PM
<Arms crossed, foot tapping> Do you really want to open the can of worms with 'girls', Mr. SB? That may make you the less intelligent sex :Neener: ...lol.

Good info! Thanks for posting it.

Melody
Oct 31st 2006, 02:56 AM
So was anyone early for work on Monday?:witch: I still haven't changed my clocks, other than the computer. I figure maybe I'll get to places on time for a change.:Embarassing:

CACAdmin
Oct 31st 2006, 01:20 PM
Work? Too busy here for work! :DevilGrin: (Actually it was my day off so I didn't have to worry about it.)

As for changing clocks, I have been doing it in stages (when I notice them). As for the TV & VCR ones... not yet. I haven't turned on the TV in days. I've been too busy hanging out here.:pumpkin:

Melody
Oct 31st 2006, 04:19 PM
I haven't turned on the TV in YEARS. Rarely watch the thing since I got my first computer. However, one might argue that looking over my tower to watch my Son's shows is technically watching TV :Angel: .